Sienci Labs LongMill V1, Инструкция по сборке

Страница: 96 / 113

96
Generally, the sizes of each model of the LongMill have been designed to fit on the following surfaces as follows:
• LongMill 12×12: Fits on a 2ft x 2ft surface
• LongMill 12×30: Fits on a 2ft x 4ft surface
• LongMill 30×30: Fits on a 4ft x 4ft surface
The diagrams below shows a more detailed view of each of the important dimensions. Note that:
1. The
red area
inside the main box shows the cutting area as an offset from the foot base
2. The blue area outside the main box shows the hanging parts as an offset from the foot base which makes up
the total machine outline
3. The area taken up by the control box isn’t accounted for in this diagram
4. If you have our dust shoe attached, your cutting area in the X-dimension will be shrunk by approximately
50mm (about 22.5mm off the left side and 27.5mm off the right side)
5. The width of the foot area is determined by the distance between the middle feet (not the front and back feet)
since the middle feet sit slightly wider than the front and back feet do
6. The red cutting area is based about the center-point of the router, thus you can plane an area larger than
what’s stated if you’re using a large surfacing bit (add your bit diameter to the width and depth of the cutting
area to find the maximum)
7. These diagrams have got a small buffer on the cutting area (i.e. it’s been shrunkened slightly) since each part
has its own manufacturing tolerance and can come together differently in assembly so we want to ensure
we’re providing a reasonable guarantee on what can be expected from your machine
8. Although the working height of the LongMill is approximately 350mm, if you’re planning an enclosure then
we’d recommend having a height of 500mm at the minimum to ensure enough space for hose management,
manipulating cutting material, etc.”