Chapter 4: Web Configuration
PPP Username
&
PPP Password:
Key in the username and password
that you received from your ISP. (e.g.,
Siemens4/Siemens4
)
Always On:
Select this item to make the
connection active all the time.
Dial on Demand:
Select this item to make a connection
automatically while in demand. Enter
the timeout to cut off the network
connection if there is no activity for
this IAD.
Manually Connect:
Select this item to make a connection
by pressing the
Connect
hyperlink on
the
Advanced Setup- Internet-
Connections
web page.
On the
Configure LAN side Settings
page, you have to fill in the data
requested.
Primary IP Address
&
Subnet Mask:
Key in the information that offered by
your ISP for the LAN connection.
Configure the secondary IP
Address and Subnet Mask:
Check this box to set up a secondary
IP Address to connect to your IAD if
they are not included in the range that
DHCP server accepts. See the next
figure for the secondary IP address
and subnet mask.
Secondary IP Address
&
Subnet
Mask:
Key in the second IP address and the
subnet mask received from the ISP for
your LAN connection.
MTU:
(refer to the WAN section)
The default
MTU
value for
LAN side
Settings
is 1500. You may modify it if
necessary.
DHCP Server On:
Check this item if DHCP service is
needed on the LAN side. The IAD will
assign IP address and gateway
address for each of your PCs.
Start IP Address
&
End IP Address:
Enter the information needed.
Lease Time:
Key in the duration for the time. The
default is 1day.
DHCP Server Off:
Check this item if DHCP service is not
needed on the LAN.
On this web page, the primary IP
address and subnet mask will be
shown on it. You can modify them
if needed.
Key in all the necessary settings
and click
Next
for the coming
page.
63
