ADSL Router User Manual
The
WAN IP settings
page will differ
slightly according to the protocol that
you choose.
This graphic is the one that you will
see if you choose the
PPPoE
mode in
the previous step. You can select
Enable NAT
or change the
MTU
value
according to your needs.
The next figure following the WAN IP
Settings in the PPPoE mode is shown
at the right. You may refer to the
Quick Setup
for further information.
If you choose
IP over ATM
from the
Connection Type
web page, you will
get a web page as the figure.
You may refer to
Quick Start-
Connection Type- IPoA
section for
more information.
Add Default Route:
Check this item to add a default IPoA
route.
After rebooting your IAD, the default
route will be shown on the
Routing
Table
under
Status
menu, you may
check it.
If you choose
Bridging
from the
Connection Type
web page, you will
get a web page as the figure listed at
the right side.
Please refer to
Quick Setup
for more
information.
78