ADSL Router User Manual
Example – Static Route
Here provides you an example of Static Route.
For the LAN shown above, if the PC in the subnet of 192.168.1.x wants to access
the PC in the subnet of 192.168.10.x, we can set a static route in the ADSL router, in
which the destination is the PC in the subnet 192.168.10.x and the gateway is router
B. The setting would be as follows:
Destination: 192.168.10.0
Netmask: 255.255.255.0 (Standard Class C)
Gateway: 192.168.1.254 (Router B)
IP Routing – Dynamic Routing
Routing Information Protocol (RIP) is utilized by means of exchanging routing
information between routers. It helps the routers to determine optimal routes. This
page allows you to enable/disable this function.
RIP Version:
It incorporates the RIP information
when receiving and broadcasting the
RIP packets. From the drop down
menu, select a RIP version to be
accepted,
1, 2
or
both
.
Operation:
There are two modes for you to
choose, Active and Passive. Select
Active
for transmitting and receiving
data, or select
Passive
for receiving
data only.
Enabled:
Check
Enabled
to enable the RIP
function on different interface.
Otherwise, disable this function.
Click
Apply
to invoke the settings set
here.
82
