Siemens SIPROTEC 6MD665, Руководство пользователя

Страница: 97 / 222

2.8 Inter relay communication
83
6MD665 Manual
C53000-G1876-C103-3
Figure 2-34 Properties dialog box — IRC combination, Updating tab
Checking the update
status Every device in DIGSI
®
which has a current parameter set is designated in column P
with a check mark. If this parameter set has already been transmitted to the real
SIPROTEC
®
4 device, you can manually make a note of this by entering a check mark
in column G. To do this, click in the corresponding check box. This selection can only
be set if the parameter set in DIGSI
®
4 is up to date.
It is automatically deleted if changes have been made which affect the parameter set
of the SIPROTEC
®
4 device concerned.
DIGSI
®
itself detects which parameter sets are no longer up to date. As soon as the
update command has been issued, these parameter sets are updated one after the
other. However, it is important for you to know after which modification which SIPRO-
TEC
®
4 device needs to be reinitialised.
Here is a brief overview:
• Changing the slot for the communications module: parameter set of the user con-
cerned.
• Modification of a serial interface setting on the tab Transmission parameters:
parameter sets of all users.
• Modification of a bus parameter in the tab Transmission parameters: parameter
set of the master.
• Routing changes in the combination matrix: parameter sets of both users con-
cerned.
• Routing changes in the device matrix of a SIPROTEC
®
4 device to IRC as the des-
tination: parameter set of the user concerned.
• Deleting or adding a user: parameter sets of all users.
Updating parameter
sets To update all outdated parameter sets, click Update all parameter sets. Messages
detailing the progress of updating are shown in the Report window. The parameter
sets are updated in DIGSI
®
.