Siemens SIMATIC HMI TP 170A, Руководство по эксплуатации оборудования, Страница: 81 / 108

System Messages
C-11
TP 170A Equipment Manual
Release 12/99
Remedy Effect/Cause Number
190010 The tag is described with values too often
(e.g. in a loop triggered by a script).
Values are lost because the maximum of 100
event have been stored in the buffer.
Increase the time interval between the
multi-writing tasks.
190011 There are two causes for this message:
S
The value entered could not be written to
the configured PLC tag because it was
either above or below the value range.
The input is rejected and the original
value is reset. Ensure that the value entered is within the
value range of the PLC tags.
S
Connection to the PLC has been
interrupted. Check the connection to the PLC.
190012 It is not possible to convert a value from a
source format to a target format, e.g.:
S
A value should be assigned to a counter
which is outside the valid,
PLC-dependent value range.
S
A tag of the type Integer should be
assigned a value of the type
String.
Check the value range or type of the
variable.
190100 The area pointer is not updated because the
configured address for this area pointer is not
available.
Type:
1
Event messages
2 Alarm messages
3 PLC acknowledgment
4 Operating unit acknowledgment
5 LED assignment
6 Trend request
7 Trend transfer 1
8 Trend transfer 2
No.
is the consecutive number displayed in
ProTool/Pro.
Check the configuration.
190101 The area pointer is not updated because it is
not possible to map the PLC type in the area
pointer type.
Parameter type and no.:
See message 190100
–
190102 The area pointer is updated following an
error status after the cause of the last error
state has been eliminated (return to normal
operation).
Parameter type and no.:
See message 190100
–
200000 Coordination is not executed because the
address configured in the PLC does not
exist/has not been set up. Change the address or set up the address in
the PLC.
200001 Coordination is not executed because the
address configured in the PLC cannot be
written. Change the address or set up the address in
the PLC in an area which can be written.
CuuDuongThanCong.com https://fb.com/tailieudientucntt