Siemens SIMATIC HMI TP 170A, Руководство по эксплуатации оборудования, Страница: 77 / 108

System Messages
C-7
TP 170A Equipment Manual
Release 12/99
Remedy Effect/Cause Number
130002 The action was not executed. Close other applications.
Delete files no longer required from the hard
disk.
140000 Online connection to the PLC has been
successfully established. –
140001 Online connection to the PLC has been
disconnected. –
140003 No tag updating or writing is executed. Check the connection and whether the PLC
is switched on.
Check the parameter definitions in the
Control Panel using “Set PU/PC interface”.
Restart the system.
140004 No tag updating or writing is executed
because the access point or the subrack
configuration is incorrect. Check the connection and whether the PLC
is switched on.
Check the access point or the subrack
configuration (MPI, PPI, PROFIBUS) in the
Control Panel with “Set PU/PC interface”.
Restart the system.
140005 No tag updating or writing is executed
because the address of the operating unit is
incorrect (possibly too high). Use a different operating unit address.
Check the connection and whether the PLC
is switched on.
Check the parameter definitions in the
Control Panel using “Set PU/PC interface”.
Restart the system.
140006 No tag updating or writing is executed
because the baud rate is incorrect. Select a different baud rate in ProTool/Pro
(according to subrack, profile,
communication peer, etc.).
140007 No tag updating or writing is executed
because the bus profile is incorrect
(see %1).
The following parameters could not be
entered in the registry:
1: Tslot
2: Tqui
3: Tset
4: MinTsdr
5: MaxTsdr
6: Trdy
7: Tid1
8: Tid2
9: Gap Factor
10: Retry Limit
Check the user defined bus profile.
Check the connection and whether the PLC
is switched on.
Check the parameter definitions in the
Control Panel using “Set PU/PC interface”.
Restart the system.
CuuDuongThanCong.com https://fb.com/tailieudientucntt