Siemens MJ-5, Руководство по установке

Страница: 36 / 39

32
BndWid ASG
Band width voltage (as voltage or percent of nominal voltage,
FPF presumed)
0
CtIDITmms ING Control intentional time delay (FPF presumed) 0
LDCR ASG Line drop voltage due to line resistance component 0
LDCX ASG Line drop voltage due to line reactance component 0
BlkLV ASG Control voltage below which auto lower commands blocked 0
BIkRV ASG Control voltage above which auto raise commands blocked 0
LimLodA ASG Limit load current (LTC block load current) 0
VLCEnable SPG enable or disable VLC 0
VRedVal ASG
Reduction of band center (percent) when voltage reduction step
is active
0
TapChgTyp ENG
Tap changer type.
E
RegTyp ENG
Regulator type
E
Syst ENG
System wiring configuration
E
DeltaPwr SPG
Delta power configuration
E
UtilPol ENG
Utility winding polarity
E
VPrimMax ENG
Maximum primary voltage
E
U2PTPri ING
Utility winding primary side
E
U2PTSec ING
Utility winding secondary side
E
P2PTPri ING
Potential transformer turns primary side
E
P2PTSec ING
Potential transformer turns secondary side
E
CTPri ING
Current transformer turns primary side
E
CTSec ING
Current transformer turns secondary side
E
IFullLoad ING
Regulating device full load rating
E
NeutOvRun ASG
Neutral over run
E
PwrFlow ENG
Power flow modes
E
BasVlt ENG
Controller nominal voltage level
E
MeterVolt SPG
Meter Display Volts
Ithres ING
Tap change minimum current (0 to 10% - default 0%)
E
Ishift ING
Current shift for reverse power flow (0° to 349° - default 0°)
E
ILodMax ING
Max. load current (for overcurrent) (0% to 350% - default 350%)
E
PTthres ING
Tap change low voltage limit (0 to 134 - default 90)
E
DmdType ENG
Method for determining command
E
DmdTime ING
Demand period length (minutes) (1 to 999 - default 30)
E
DmdSubPer ING
Number of demand subperiods (for sliding window mode only)
E
AutoVariAmp SPG
Automatic Variamp protection
E
SoftVariAmp SPG
Software Variamp setting
E
Rlimit ENG
Raise limit (Alter & Soft Variamp)
E
Llimit ENG
Lower limit (Alter & Soft Variamp)
E
SlaveMaster ENG
Put two tap changers in locked step
E
TapAlertEna SPG
Enable or disable tap alert
E
TapResync SPG
Synchronizes tap position at neutral
E
RLOnTime ASG
maximum time to keep the tap changer motor running before
pausing for RLOffTime (in seconds)
E