Siemens HR676G8.1A, Инструкция по эксплуатации

Страница: 33 / 64

Trouble shooting
en
33
3
Trouble shooting
Trouble s hooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Note:
If a dish does not turn out as well as you had
hoped, refer to the table section at the end of the
instruction manual, where you will find plenty of tips and
information.
~
"Tested for you in our cooking studio"
on page 36
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
If an error message beginning with 'E' is shown, e.g.
E0111, switch the appliance off and then on again. If
this message appears again, contact the after-sales
service.
--------
Fault Possible cause Information/remedial action
The appliance does not work The fuse is faulty Check in the fuse box to make sure that the fuse for
the appliance is in working order
Power cut Check whether other kitchen appliances are working
The appliance door will not open; the
5
symbol is shown in the display
The appliance door is locked until the cooking com-
partment has cooled down.
Wait until the
5
symbol goes out
Although the appliance is switched
on, it cannot be operated; the
1
symbol is shown in the display
The child lock is activated Press and hold the
1
button until the
1
symbol
goes out
The cooking compartment does not
heat and "Demo mode on" is shown in
the display
The appliance is in demo mode Switch off the fuse in the fuse box and switch it back
on again after approx. 10 seconds. Switch on the
appliance and select "Demo mode off" in the settings.
The interior lighting has failed The LED bulb is defective Call the after-sales service
Operations with steam or descaling
do not start or do not continue
Water tank empty Refill water tank
The panel is open Close the panel
Descaling locks operations with steam Carry out descaling
Faulty sensor Call the after-sales service
The appliance prompts you to descale The power supply was interrupted or the appliance
was switched off during the descaling process
Continue the descaling process after switching the
appliance on again
The appliance prompts you to descale
without the counter appearing before-
hand
The set water hardness range is too low Carry out descaling
Check the set water hardness range and adjust it, if
necessary
Buttons flash Normal occurrence caused by condensation behind
the control panel
As soon as the condensation has evaporated, the but-
tons no longer flash
Cooked dishes turn out too moist or
too dry when cooking with steam-
assisted applications
The wrong steam intensity was selected Select a higher or lower steam intensity
The message "Tank empty" appears,
even though the water tank is filled
The panel is open Close the panel
Faulty sensor Call the after-sales service
The panel for removing the tank does
not open
The plug is not plugged into the mains Connect the appliance to the electricity supply
Power cut Check whether other kitchen appliances are working
The circuit breaker is faulty Check in the fuse box to make sure that the fuse for
the appliance is in working order
X
field sensor faulty Call the after-sales service
If required, empty the water tank: Open the appliance
door, take hold of the lower part of the panel on the
left and right with your fingers and pull out the panel
Steam escapes from the ventilation
slots during cooking
Normal procedure Not possible
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused by the
steam
Not possible