Siemens HR676G8.1A, Инструкция по эксплуатации

Страница: 15 / 64

Before using for the first time
en
15
--------
K
Before using for the first
time
Before us ing for t he first time
Before you can use your new appliance, you must
make some settings. You must also clean the cooking
compartment and accessories.
Before using for the first time
Before using the appliance for the first time, enquire
about the water hardness of your tap water from your
water supplier.
So that the appliance can reliably remind you to
decalcify it when required, you must correctly set your
water hardness range.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or non-
carbonated mineral water.
Notes
■
If your water is very hard, we recommend that you
use softened water.
■
If you only use softened water, you can set the water
hardness range to "softened" in this case.
■
If you use mineral water, set the water hardness
range to "4 very hard".
■
If you use mineral water, you must only use non-
carbonated mineral water.
Initial use
After connecting the appliance to the power or following
a power cut, the settings for initial use are shown in the
display.
Note:
You can change these settings at any time in the
basic settings.
~
"Basic settings" on page 23
Setting the language
German is the preset language.
1.
Use the rotary selector to select the required
language.
2.
Touch the
¿
arrow.
The next setting appears.
Pull-out system, 2 levels
The pull-out rails at levels 2 and 3 allow you to pull
the accessories out further without them tipping.
HZ638270
Self-cleaning
Pull-out system, 3 levels
The pull-out rails at levels 1, 2 and 3 allow you to
pull the accessories out further without them tip-
ping.
HZ638370
Self-cleaning
Water hardness range Setting
0 0 softened
1 (up to 1.3 mmol/l) 1 soft
2 (1.3 - 2.5 mmol/l) 2 medium
3 (2.5 - 3.8 mmol/l) 3 hard
4 (above 3.8 mmol/l) 4 very hard