Siemens HR676G8.1A, Инструкция по эксплуатации

Страница: 19 / 64

Steam
en
19
Starting
1.
Fill the water tank.
Note: Only switch on Dough proving once the
cooking compartment has completely cooled down
(to room temperature).
2.
Touch the Menu button.
3.
Touch the "Steaming" field.
4.
Use the rotary selector to set to "Dough proving
R
".
5.
Touch the "Temperature" field and set the
temperature using the rotary selector.
6.
Touch the "Duration" field and set the duration using
the rotary selector.
7.
Press the Start/Stop button to start.
The appliance heats up. Once the appliance has
heated up, an audible signal sounds and the
operation begins.
A signal sounds. The oven stops heating. You can
cancel the audible signal early using the
0
button.
Cancelling
Touch the Start/Stop button to cancel the operation.
Finishing
Touch the On/Off button to switch off the appliance.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly.
~
"Basic settings" on page 23
:
Warning
Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning
Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Notes
■
If your water is very hard, we recommend that you
use softened water.
■
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
■
If you use mineral water, set the water hardness
range to "4 very hard".
■
If you use mineral water, you must only use non-
carbonated mineral water.
1.
Touch the
X
field.
The control panel is automatically pushed forwards.
2.
Pull the control panel forwards with both hands and
then push it upwards until it locks into place (Fig.
!
).
3.
Lift the water tank and remove it from the water tank
recess (Fig.
"
).
4.
Fill the water tank with cold water up to the “max.”
mark (Fig.
#
).
5.
Insert the filled water tank (Fig.
$
). Ensure that the
water tank locks into place behind both holders
‚
(Fig.
%
).
6.
Slowly push the control panel downwards and then
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
2I 1
I
D
D
I