Rails
en
31
Descaling programme interrupted
If descaling is interrupted (for example, due to a power
failure or because the appliance is switched off), the
descaling symbol appears on the display after the
appliance is switched back on. You will be prompted to
rinse three times. The appliance cannot be used for
other operations until the third rinse cycle comes to an
end. If you set another operation, "
’‚Ÿ
" (Cleaning)
appears on the display. Repeat the interrupted
descaling programme after rinsing.
1.
Empty the water tank and clean thoroughly with
water.
2.
Insert the empty water tank.
3.
Use the function selector to set descaling.
4.
Turn the temperature selector.
"
‹Ÿ
" appears on the display. After a few seconds,
the remaining liquid pumped back.
5.
Empty the water tank and clean thoroughly with
water.
6.
To rinse the steam system, run the three rinse cycles
in the descaling programme.
7.
Restart descaling.
p
Rails
Rails
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
1.
Lift the rail slightly at the front
‚
and detach it
ƒ
(figure
!
).
2.
Then pull the whole rail towards you and take it out
(figure
"
).
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Attaching the rails
The rails only fit on the right or the left side. For both
rails, ensure that the curved rods are at the front.
1.
First, insert the rail in the middle of the rear socket
‚
,
until the rail rests against the cooking compartment
wall, and push it back
ƒ
(figure
!
).
2.
Then insert the rail into the front socket
„
, until the
rail also rests against the cooking compartment wall
here, and press it downwards
…
(figure
"
).
Fitting and removing the pull-out rails
On appliance models with shelf supports, you must
change the basic settings to "Telescopic rails: Yes".For
more information, refer to the "Basic settings" section.
If necessary, you can use pull-out rails on all levels.
If your appliance features the EcoClean Direct cleaning
function, you will need to take the entire shelf supports
for fitting and removing the pull-out rails out of the
cooking compartment. Otherwise, the EcoClean Direct
coating may be damaged.
If your appliance features the pyrolytic self-cleaning
function, you will need to take the pull-out rails out of
the cooking compartment before running the cleaning
function.The pull-out rails are not suitable for pyrolytic
self-cleaning.
Notes
■
Only use the pull-out rails in conjunction with the
universal pan, baking tray, wire rack and
accessories that are placed on the wire rack. All
other accessories are unsuitable.
■
The pull-out rails are not suitable for appliances with
a microwave function.
2
1
D
E
2
F
G
1
D
E
