TEST MODE
STEP 1—ENTERING THE TEST MODE
The TEST mode is used to test a device. Press the TEST key to enter
this mode. The Programmer/Tester displays the following message:
Searching For
Device
CAUTION
1. TO PREVENT DAMAGE TO THE FPI-32, DO NOT CONNECT
CZM-1s, TRIs/MSIs, or ICPs/VCPs to the FPI-32 until all wiring
is removed from the CZM-1, term 1 and 2, the TRI/MSI, term 1
and 2, or the ICP/VCP, TB1, term 1 and 2.
2. Only one device should be connected to the FPI-32 at a time.
Install the device: no response necessary.
NOTE:
The Programmer/Tester is no longer equipped with polarity re-
versal for modules connected to the FPI-32 through the exter-
nal programming cable (TRI, MSI, CZM, VCP/ICP). The user
may have to manually reverse the polarity of the connect cable.
While in the
searching mode,
the FPI-32 display will periodi-
cally remind the user to check/reverse the polarity of the cable
connection.
NOTE:
The Programmer/Tester automatically detects the presence of
the inserted device. There is no need to depress any keypad
keys once the device has been inserted. When the device is
detected, the Programmer/Tester responds with:
TESTING DEVICE
PLEASE WAIT...
NOTE:
During the testing, the LED on the device flashes and relays on
a relay-based device activate. At this point, the device will
either PASS or FAIL.
TEST MODE
16
firealarmresources.com
