PROGRAM MODE
11
STEP 5 — VERIFYING DEVICE INFORMATION FOR TRI
DEVICES
If the device is a single address TRI,
the display shows the following
message, depending on the selection made in the previous steps:
@@ **** TRI
ADR: *1, OK?
Where:
@@ = NO or NC; the type of switch selected.
**** = Status, Trouble, or Alarm; the type of switch selected.
*1 = The first logical address for the device.
If the device is a dual address TRI,
the display shows the following
message, depending on the selection made in the previous steps:
@1/@2 ***1/***2
ADR: *1, *2, OK?
Where:
@1 = NO or NC; the type of switch selected at address 1.
@2 = NO or NC; the type of switch selected at address 2.
***1 = STAT, TRBL, or ALRM; the type of switch selected at address 1.
***2 = STAT, TRBL, or ALRM; the type of switch selected at address 2.
*1 = The first logical address for the device.
*2 = The second logical address for dual devices.
Respond:
YES
- The Programmer/Tester enters Step 9.
NO
- The Programmer/Tester enters Step 2.
C
- Same response as
NO
above.
firealarmresources.com