Siemens 1LA8, Руководство по эксплуатации

Страница: 66 / 174

6.3.4 Connecting the grounding conductor
The grounding conductor cross-section of the machine must be in full conformance with the
installation specifications, e.g. according to IEC / EN 60204-1.
Table 6-2 Determining the cross-section of the grounding conductor
Phase conductor cross-section S
[mm²]
Cross-section of grounding conductor
[mm²]
S > 35 S/2
There is a hexagon bolt with a flat washer and a spring washer on the stator frame at the
designated connecting point for the grounding conductor. The grounding conductor can be
connected as follows:
● With stranded cables with cable lugs
● With flat cables with cable end designed accordingly
As an alternative, you can connect the grounding conductor without cable lugs using a terminal
plate at the marked connection point.
Connecting the grounding conductor
● Ensure that the connecting surface is bare and is protected against corrosion using a
suitable substance, e.g. acid-free vaseline.
● Arrange the flat washer and spring washer under the bolt head.
● Check that the maximum permissible clamping thickness of 10 mm for the cable lug or strap
is not exceeded.
● Fasten the clamping screw according to the following table. Screw-in depth and tightening
torque are different depending on whether cable lugs or ground terminals are used.
Screw Screw-in depth Tightening torque
When using cable lugs M12 x 25 > 16 mm 38 Nm
M16 x 35 > 20 mm 92 Nm
When using grounding
terminals
M6 > 9 mm 8 Nm
M8 > 12 mm 20 Nm
M10 > 15 mm 40 Nm
M12 > 18 mm 70 Nm
M16 > 20 mm 170 Nm
● Use the connecting terminals designated for the grounding conductor in the terminal box.
See also
Converter operation (Page 79)
Electrical connection
6.3 Preparation
SIMOTICS TN Series N-compact 1LA8
66
Operating Instructions 05/2014