Siemens 1LA8, Руководство по эксплуатации

Страница: 106 / 174

9.1.9 Regreasing intervals and types of grease for operating roller bearings
The specified grease data applies to the data specified on the rating plate and for high-quality
grease in accordance with the specifications in these operating instructions. Because these
greases exceed significantly the requirements according to DIN 51825 and ISO 6743‑9, they
permit the specified relubrication intervals.
Initial lubrication
The grease specified on the lubricant plate is selected according to the operating conditions
known at the time of ordering and should be used for initial lubrication.
Grease selection criteria
High quality ISO‑L‑X BDEA3 lubricating grease according to ISO 6743-9 and K3K‑20
lubricating grease according to DIN 51825 with lithium soap as a thickener and an upper
service temperature of at least +130° C / +266° F are permissible for standard applications
without special requirements.
When selecting the lubricating grease, ensure that the technical data of the grease is suitable
for the application.
The lubricating grease must satisfy the criteria listed in the table below and must match the
operating conditions.
Table 9-3 Criteria for selecting roller bearing greases
Criteria Standard Property, characteristic value Unit
Type of base oil - Mineral oil -
Thickener - Lithium -
Consistency in accordance with
NLGI class
DIN 51818 ● "3" for vertical and horizontal types of
construction
● "2" alternatively for horizontal type of
construction with reduced lubrication interval
-
Operating temperature range - At least -20° C ... +130° C °C
Dropping point DIN ISO 2176 At least +180° C °C
Basic oil viscosity DIN 51562-1 ● Approx. 100 mm²/s at 40° C
● Approx. 10 mm²/s at 100° C mm²/s
Additives - ● Anti-Oxidation (AO), Anti-Wear (AW)
● No solid lubricants
● Alternative: Extreme-pressure (EP) only after
consultation with grease and bearing
manufacturers
-
FE9 test: A/1500/6000 DIN 51821-1/-2 F10 ≥ 50 h at +130° C
F50 ≥ 100 h at +130° C H
Behavior in the presence of water DIN 51807 0 or 1 at a test temperature of +90° C -
Corrosive effect on copper DIN 51811 0 or 1 at a test temperature of +120° C Corr. °
Resistance to corrosion (EMCOR) DIN 51802 /
ISO 11007 0 - 0 Corr. °
Maintenance
9.1 Inspection and maintenance
SIMOTICS TN Series N-compact 1LA8
106
Operating Instructions 05/2014