14
SRV285 TC
1.0.3 - 2015
Montering av oljetank
NO
Fitting the oil tank
EN
1.
First, make sure to check oil level in gearleg before the fitting proce
-
dure. If oil level in gearleg is low make sure to refill oil from bottom
oil drain point. (Screw is M8) (1)
2.
Fit the oil tank above the waterline by at least 20% of the distance
from the waterline to the centre of the tunnel. This is for ensuring
enough overpressure of oil in the gearhouse.(2)
3. Fit the oil tube to the tank and the feed pipe to the pivot shaft. Tight-
en the tube clamp screws. Make sure that the oiltube has no loops
that makes an airlock to stop the oil flow and has a good angle to
allow the oil to flow freely into the gearhouse.
4. Fill the oil tank with gear oil type EP90.
5.
When changing gear oil, refill and drain gearleg simultaneously to
secure that the system will not be emptied.
1.
Kontroller at girhus er forhåndsfylt med olje. Om ikke oljenivået
er tilfredstillende MÅ det etterfylles olje fra undersiden av girhus.
(Skrue er M8) (1).
2.
Monter oljetank over vannlinjen minimum 20% av avstanden
fra vannlinje og til center av tunell. Dette for å skape nok overtrykk
i girhuset.
3.
Fest oljeslange til oljetank, deretter fest materør til oljeinntak
på pivot/dreie- aksel. Stram til slangeklemmene. Det er viktig at
oljeslangen har minst mulig vinkler og at oljen får strømme så fritt
som mulig.
4.
Fyll oljetank med girolje EP90.
5.
Når girolje i girhuset skal skiftes, må det etterfylles samtidig som
man drenerer, Dette for å sikre at girhuset ikke går tomt for olje
under byttet.
Fig. 10h
Document1
2
1.1
Snapshot
Document1
2
1.1
Snapshot
(1)
1
1
2
2
3
3
4
4
5
5
6
6
A
A
B
B
C
C
D
D
olekr
14.01.2015
Designed by
Checked by
Approved by
Date
1 / 1
Edition
Sheet
Date
Present issues:
1. Aproximately 5mm of the tunnel end covers have been cut, due to
adjustments. This causes incorrect angel and alignment.
2. Actuator support brackets have been moved to adjust. This also
causes incorrect angel and alignment.
Actions to be done:
3. Place and mould in an wedge between the upper and lower flanges
to adjust to correct angel and alignment.
4. Replace retract mechanism (without engine.)
1
1
2
2
3
3
4
4
5
5
6
6
A
A
B
B
C
C
D
D
olekr
16.03.2015
Designed by
Checked by
Approved by
Date
1 / 1
Edition
Sheet
Date
842,46
709,05
580,00
73
2,
26
43
9,
75
413,24
11
6,
40
Document1
2
1.1
Snapshot
D
min. 0,2 x D
(2)
Pivot shaft
Oil tank