Side-Power S-link PJC-212, Инструкция по установке и эксплуатации

Страница: 10 / 24

10
PJC211/212/221/222
2.0.2 - 2013
SETUP PROCEDURE
RUN SETUP! DEVICES IN CONFLICT!
Detectet devices in conflict. Two or more thrusters defined as same instance
(bow/stern/bow STB/Stern STB). Run Setup procedure to correct.
Thrusters can not be operated until seup is completed.
SETUP DO NOT MATCH SYSTEM.

FOR AUTO SETUP
New devices found. Not in conflict with other devices.
Press button below the -symbol to auto setup.
Thrusters can not be operated to auto setup is completed.
The setup procedure requires knowledge of the serial numer and location of all the S-link
devices.
Write this down in the form on the last page to have the information at hand when doing a
manual setup.
Press and hold the button marked “MENU” for 3 seconds to enter the menu sys-
tem. Use the (stern) joystick to select “SETUP”, Press button below the
-symbol to enter the”SETUP”-menu.
Use the (stern) joystick to select “SYSTEM DEVICES”,
Press button below the -symbol to enter the”SYSTEM DEVICES”-menu.
Use the (stern) joystick to set the pin code one number at the time,
press button below the -symbol to jump to next number and confirm.
The pin code is “9 9 9 9”.
NOTE: Re-entering the SYSTEM DEVICES menu within 15 minutes does not
require entering PIN code
The devices found in the system is now displayed with their instance and serial
number.
Go through all devices and make sure that they are set to the correct instance
and function (refer to detailed instructions in the SETUP section of “Menu
System”-chapter).
Press button below the -symbol to save setting and return to “Setup”-
Menu.
At the first startup of a new system, one of the two screens below will be shown: