31
Order code: 44510
Pixel Controller
No Response to DMX
Suspect the DMX cable or connectors or a controller malfunction.
01)
Check the DMX settings. Make sure that DMX addresses are correct.
02)
Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
Problem
Probable cause(s)
Solution
One or more fixtures
do not function at all
No power to the fixture
●
Check if power is switched on and
cables are plugged in
Primary fuse blown
●
Replace fuse
The device responds
erratically
The factory settings of the device
are changed
●
Reset the device’s parameters to the
default factory settings. See 7. Factory
Reset on page 25
The device does not
respond to DMX
control
The lighting controller is not
connected
●
Connect lighting controller
3-pin/5-pin DMX OUT of the lighting
controller does not match DMX IN
of the first fixture on the link (i.e.
signal is reversed)
●
Install a phase reversing cable
between the lighting controller and the
first fixture on the link
The controller is defective
●
Try using another controller
Poor data quality
●
Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link
Bad data link connection
●
Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables
Data link not terminated with 120
Ohm termination plug
●
Insert termination plug in output jack of
the last fixture on the link
Incorrect addressing of the fixtures
●
Check address settings
One of the fixtures is defective and
disturbs data transmission on the
link
●
Bypass one fixture at a time until normal
operation is regained: unplug both
connectors and connect them directly
together
●
Have the defective fixture serviced by
a qualified technician
3-pin DMX OUT on the fixtures does
not match (pins 2 and 3 reversed)
●
Install a phase-reversing cable
between the fixtures or swap pin 2 and
3 in the fixture, that behaves erratically
No light or LEDs cut
out intermittently
Fixture is too hot
●
Make sure air vents are not blocked
LEDs are damaged
●
Disconnect fixture and return to your
dealer
The power supply settings do not
match local AC voltage and
frequency
●
Disconnect fixture. Check settings and
correct if necessary
Содержание 44510
Страница 18: ...17 Order code 44510 Pixel Controller Menu Overview ...
Страница 34: ...33 Order code 44510 Pixel Controller Notes ...
Страница 35: ...34 Order code 44510 Pixel Controller ...
Страница 36: ... 2020 Showtec ...
