Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028
www.shorestation.com
0004160
Page
20
of
25
Rev
B
10/7/2010
Place the front and rear platform tube assemblies on the lower frame so the cotter keyed end of the
pulley pins are to the inside of the lift and the end with the cable coming out the bottom will be to the
winch side of the lift. Insert a 3/8 X 1 1/4 carriage bolt into the corner guide and slide into the top slot
on the outside of the platform tube assembly and secure with a flat washer and flange lock nut. Repeat
for the other three corners.
Do not tighten at this time.
Insert 3/8” X 1” carriage bolts in the slots
on the inside of both the front and rear
platform tubes and slide them inside the
exposed end of the pulley pin. Mount the
platform support channel over the bolts
and secure with hex flange locknuts.
