-28-
Model W1855 (For Machines Mfd. Since 6/17)
SE
RV
IC
E
SERVICE
General
The work table must be adjusted so that the miter slot is
parallel to the sanding disc (for accurate miter sanding),
and the gap between the work table and sanding disc is
not more than
1
⁄
16
" (to minimize risk of pinch injury).
Work table alignment should be checked and adjusted, if
necessary, before each use or any time the work table is
removed and re-installed.
Adjusting.Work.Table
MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
To.adjust.work.table,.do.these.steps:
1
. DISCONNECT MACHINE FROM POWER!
2
. Set work table angle to 0° (see
Setting.Work.Table.
Angle.
on
.Page.19
).
3
. Check miter slot parallelism by measuring distance
from each end of sanding disc to edge of miter slot
(see
Figure
27
). Distance "A" should be equal to
distance "B" with not more than a
1
⁄
16
" gap between
table and sanding disc.
— If distance "A" is
not
equal to distance "B" or gap
between table and disc exceeds
1
⁄
16
", proceed to
Step.4
.
4
. Loosen flange nuts shown in
Figure.28
, and adjust
table so distance "A" equals distance "B" (see
Figure
27
), with not more than a
1
⁄
16
" gap between table
and sanding disc.
5
. Re-tighten flange nuts from
Step.4
. Re-check miter
slot parallelism and spin disc by hand to verify that
sanding disc does not touch work table. If necessary,
repeat
Steps.3–5
until work table is properly
adjusted.
Figure.27.
Work table alignment.
A
B
1
⁄
16
" Gap
Figure.28.
Work table alignment nuts.
x 3
