-19-
Model W1855 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Setting.Work.Table
Only. sand. workpiece. on. side. of. sanding. disc. that.
is. rotating. down. toward. work. table.. This. will. keep.
workpiece.from.flying.out.of.your.hands.from.rotational.
force.of.disc.
Figure.14.
Components for setting work
table angle.
Work Table
Support
Pointer
Angle
Scale
Square
Angle
Adjustment
Knob
Figure.15.
Components for setting miter
gauge angle.
Miter Gauge
Lock Knob
Pointer
Scale
To.set.work.table.angle,.do.these.steps:
1
. DISCONNECT MACHINE FROM POWER!
2
. Loosen angle adjustment knob, and position work
table to desired angle using angle scale (see
Figure
14
).
3
. Re-tighten angle adjustment knob.
Set the work table angle relative to the sanding disc. The
angle can be set using the angle scale on the sander body,
or for greater accuracy, a protractor or machinist's square
can be used.
To.set.miter.gauge.angle,.do.these.steps:
1
. Place miter gauge in work table slot, and loosen lock
knob shown in
Figure.15
.
2
. Rotate
miter gauge to desired angle on scale, then
re-tighten lock knob.
Note:
For instructions on calibrating your miter
gauge, see
Calibrating Miter Gauge
on
.
Page 29
.
Setting.Miter.Gauge
