-23-
Model W1855 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
The Model W1855 Disc/Belt Sander accepts 6" diameter
cloth- or paper-backed pressure sensitive adhesive (PSA)
sandpaper discs. These are available in a variety of grits
through the Woodstock catalog. See
Accessories.
on
Page.
26
.
The PSA sandpaper discs stick directly to the surface of
the aluminium disc.
Changing/Replacing.
Sandpaper.Disc
1.
DISCONNECT MACHINE FROM POWER!
2
. Remove work table.
3
. Remove
(2) M4 x 10 tap screws and disc cover shown
in
Figure
22
.
4
. Remove old sandpaper disc from aluminium disc.
x 2
Figure.22.
Removing disc cover.
Disc Cover
Removing.Sandpaper.Disc
Figure.23.
Installing sanding disc.
1
. Peel back protective layer from one-half of new
sandpaper disc, and fold it against remaining half.
2
. Center sticky half of sandpaper disc on upper half
of aluminum disc, and press sandpaper disc onto
surface (see
Figure.23
).
3
. Remove remaining half of protective layer from
sandpaper disc, then press remaining portion of
sandpaper disc onto aluminum disc.
4
. Rotate disc by hand and check to make sure
sandpaper is firmly attached to disc without any
bumps or wrinkles.
5
. Re-install disc cover and work table.
6
. Check work table alignment and adjust if necessary
(see
Aligning.Work.Table.
on
Page.28
).
Attaching.Sandpaper.Disc
