-15-
Model W1855 (For Machines Mfd. Since 6/17)
SE
TU
P
Assembly
Figure.8.
Installing disc cover.
Figure.9.
Installing work table.
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of the
heavy-duty rust-preventative applied at the factory, if
applicable. Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
To.assemble.machine,.do.these.steps:
1
. Attach sandpaper disc to aluminium disc (see
Changing/Replacing.Sandpaper.Disc.
on
Page.23
).
2
. Mount disc cover to holes in sander body near
bottom of aluminium disc, using (2) M4 x 10 tap
screws, as shown in
Figure
8
.
3
. Install 6mm fender washer on table lock knob, as
shown in
Figure
9
.
4
. Insert work table index pin into upper hole on sander
base (see
Figure
9
).
5
. Insert threaded end of table lock knob through slot
in work table and into threaded hole in sander body.
6
. Set work table at desired angle and tighten table
lock knob.
7
. Insert (2) M8-1.25 x 16 cap screws with (2) 8mm flat
washers through slot in backstop and thread into
mounting holes in sander body (see
Figure.10
).
Note:
Do not fully tighten cap screws yet.
8
. Use a square to position backstop perpendicular
to sanding belt, with a gap of approximately
1
⁄
8
"
between backstop and belt, then tighten cap screws
from
Step.7.
(see
Figure
11
).
Table Lock
Knob & Washer
Upper Hole
Index Pin
Threaded Hole
The Model W1855 ships with the sanding belt
pre-installed.
x 2
Disc Cover
Figure.10.
Backstop mounting location.
x 2
Backstop
1
⁄
8
" Gap
Figure.11.
Squaring backstop.
