-44-
Model W1842 (For Machines Mfd. Since 6/17)
M
A
INTE
N
A
N
CE
Leadscrews
Lube Type ...................................NLGI#2 Equivalent
Amount ................................................ Thin Coat
Frequency ..................... Every 160 Hours of Operation
Raise table bed all the way to expose the leadscrews.
Use mineral spirits, shop rags, and a brush to clean debris
from the leadscrew (see
Figure.40
). When dry, brush on a
light application of multi-purpose grease to the leadscrew
threads.
Use a clean brush to apply a thin coat of ISO 68 machine
oil to the outside surface of the columns (see
Figure.41
)
Move the table up and down to distribute the lubricant.
This machine features bearings that are lubricated and
sealed at the factory. These bearings do not require any
service unless they need to be replaced. If a bearing fails,
your machine will probably develop a noticeable rumble
or vibration, which will increase when under load.
Follow the maintenance schedule on
Page.43
and the
procedures starting on this page to properly lubricate the
components, which are essential for long life and trouble-
free operation of your machine.
Items.Needed.
Qty
NLGI#2 Grease or Equivalent ..................... As Needed
ISO 68 Oil ............................................. As Needed
Clean Shop Rags ..................................... As Needed
Mineral Spirits ....................................... As Needed
Stiff Brush ........................................................1
Lubrication
Failure.to.follow.reasonable.lubrication.
practices.as.instructed.in.this.manual.for.
your.machine.could.lead.to.premature.
failure. of. components. and. void. the.
warranty.
Figure.40.
Location of leadscrews.
Leadscrews
Figure.41.
Location of columns.
Columns
(2 of 4)
Columns
Lube Type ....................................ISO 68 Equivalent
Amount ................................................ Thin Coat
Frequency ...................... Every 40 Hours of Operation
Raise table bed all the way to expose the leadscrews.
Use mineral spirits and shop rags to clean debris from
the column. Use a clean brush to apply a thin coat of
ISO 68 machine oil to the outside surface of the columns
(see
Figure.41
). Move the table up and down to distribute
the lubricant.
Содержание W1842
Страница 65: ...Model W1842 For Machines Mfd Since 6 17...
Страница 68: ......