Shop fox W1842, Руководство пользователя

Страница: 52 / 68

-50-
Model W1842 (For Machines Mfd. Since 6/17)
SE
RV
IC
E
Feed.Roller.Height
Figure.51.
Inspecting infeed roller height
with gauge block.
Infeed
Roller
Tools.Needed:
Gauge Block (Not included) ...................................1
Feeler Gauge (Not included) ..................................1
The infeed and outfeed rollers move the lumber through
the planer/moulder, and press the lumber flat against the
work table.
For use as a planer, set the infeed and outfeed rollers to
0.08" below the cutterhead knife edge at bottom dead
center. For use as a moulder follow the instructions on
Pages 32–34
to install the moulding fences, bedboard, and
moulding knives.
1...
DISCONNECT MACHINE FROM POWER!
2.
Make wooden gauge block shown in
Figure.50
.
3.
Raise table until gauge block barely touches infeed
roller (see
Figure.51
).
4.
Slide gauge block over so it is under edge of one of
the knives. Turn cutterhead until one of the knives is
at bottom dead center over gauge block.
5.
Measure clearance between top of gauge block and
edge of knife with a feeler gauge. Feeler gauge
measurement should be 0.08".
6.
Repeat
Steps.1–5
for opposite side of roller. Repeat
all steps for outfeed roller.
Checking.Roller.Height
Figure. 50. .
Gauge block dimensions.
45°
2"
4"
1
1
/
2
"
1
/
2
"
4"
Grain Direction
Side View
Front View
Gauge
Block