Shop fox W1842, Руководство пользователя

Страница: 39 / 68

-37-
Model W1842 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Edge.Moulding
Certain moulding tasks require the workpiece to be
oriented vertically, and thus extra-tall wood fence rails or
guide boards are needed.
Components.and.Hardware.Needed:. Qty
Wood Fence Rail Material (Not included) ...................2
Tools.Needed:
C-Clamps (Not included) .......................................4
To.perform.edge.moulding.operations,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Build wooden fence rails that are
3
⁄
4
" shorter
than workpiece and same length as work table
(see
Figure.34
).
3. Raise work table until a knife that is at bottom dead
center is below the height of the wooden fence rails.
4. Align fence rails to knives by sliding wooden
fence rails against knife edge using metal fence
rails. Tighten lock knob on metal fence rails (see
Figure.34
).
5. Clamp wooden fence rails to table with C-clamps, or
screw wooden fence rails to bedboard.
6. Adjust the feed rollers as described in Steps.15–17
on
Page.35.
7. Operate as described in the Moulding Operation.
section.
Figure.34.
Example of edge moulding
fence rail setup.
Metal
Fence Rail
Metal
Fence Rail
Knife
3
/
4
"
Workpiece
Bedboard
Work Table
Lock Knobs
Wood
Fence
Rail
Wood
Fence
Rail