Shop fox W1842, Руководство пользователя

Страница: 21 / 68

-19-
Model W1842 (For Machines Mfd. Since 6/17)
SE
TU
P
Figure.13.
Dust hood installed.
4. Slide dust hood under chip guard bracket and secure
top with (3) M5-.8 x 8 cap screws and (3) 5mm
lock washers and secure bottom with (1) M6-1 x 12
cap screw and (1) 6mm lock washer, as shown in
Figure.13
.
5. Attach handwheel handle to handwheel, then place
handwheel over shaft shown in
Figure.14
, and
rotate handwheel until pin in shaft slides into groove
in handwheel.
Figure.14. Installing handwheel.
Figure.15.
Knife-setting jig assembled.
E-Clips
E-Clips
Shaft
Feet
Dust Hood
x 3
x 1
Shaft
Groove
Pin
Handwheel Handle
6.
Attach (1) 9mm E-clip to notch on one end of knife-
setting shaft (see Figure.15 ).
7. Slide cast-aluminum knife-setting jig feet onto shaft
(see
Figure.15
) and slide each to an end.
8..
Attach (1) 9mm E-clip to notch at other end of
shaft, then attach (2) 9mm E-clips (see Figure 15) to
interior notches to secure feet.