-38-
Model W1842 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Moulding.Do's.&.Don'ts
The Model W1842 will accommodate most moulding knife
profiles. However, you must still pay special attention to
workpiece support and knife-to-table clearance. Refer to
the following examples to avoid common workpiece setup
mistakes.
Figure.35
. Example of edge-forming
profile hazards.
Top View
CORRECT
CORRECT
Custom
3-Piece
Guide
Rail System
Mounted to
the
Sacrificial
Table
(Bedboard)
End View
End View
INCORRECT
Edge-Forming.Knife.Clearance
A wooden sacrificial table clamped to the cast-iron
table and a three-piece guide system (see
Figure 35)
can prevent tool and table damage by absorbing the full
sweep of the knife.
Never attempt to use edge-forming profile knives without
pre-installing a wooden sacrificial table or bedboard (refer
to
Bedboard
on
Page.33
for further detail). Often these
types of knives sweep lower than the workpiece and could
contact the table at the bottom, as shown in
Figure 35,
causing severe machine damage or personal injury.
Moulding knives have many different profiles. Before
starting the machine, always verify that the moulding
knives do not contact any part of the workpiece guide
rails, feed roller swing arm, or the table surface.
Failure to verify knife clearance may result in severe
injury and machine damage!
Sacrificial Table
Содержание W1842
Страница 65: ...Model W1842 For Machines Mfd Since 6 17...
Страница 68: ......
