-48-
Model W1745W (For Machines Mfd. Since 9/16)
SE
RV
IC
E
5.
Look down length of straightedge on outfeed side to
see if there are any noticeable gaps between straight-
edge and outfeed table. Do this at both front and rear
of table.
— If there are no gaps, and the straightedge makes
full contact with both tables at front and rear, the
tables are parallel with each other and no adjust-
ments are necessary.
— If there are gaps anywhere between one of the
tables and the straightedge, the tables are not par-
allel to each other and must be adjusted. Proceed
to
Step 6
.
6.
Insert feeler gauge between table and straightedge
where gap is greatest (see
Figure 77
). Maximum
allowable tolerance is 0.003".
7.
Loosen outfeed table locks. Place shims between
dovetailed ways (see
Figure 78
) until outfeed table is
within 0.003" of parallel with infeed table at front and
rear of tables.
8.
Re-check outfeed table height (refer to
Setting
Outfeed Table Height
on
Page 25)
, and re-adjust if
necessary.
Straightedge
Infeed
Outfeed
Insert Feeler Gauge
Where Gap is Greatest
Figure 77.
Example of feeler gauge
location for checking table parallelism.
Figure 78.
Locations to place shims when
adjusting table parallelism.
Possible Shim
Locations
