-38-
Model W1745W (For Machines Mfd. Since 9/16)
SE
RV
IC
E
Lubrication
Since all bearings are sealed and permanently lubricated,
simply leave them alone until they need to be replaced.
DO NOT lubricate them.
Provided is a list of components that require periodic
lubrication. Be careful not to over-lubricate these
components. Large amounts of lubricant will attract
sawdust, causing the metal components to gum-up and
bind.
Sliding Ways
Oil Type ............................... ISO 68 Way Oil or Equivalent
Oil Amount ..........................................................1–2 Drops
Lubrication Frequency .......................................As Needed
Lower both infeed and outfeed table to access the sliding
ways. Place a couple of drops of oil at top of each sliding
surface as needed and move tables up and down to distrib-
ute oil (see
Figure 53
). Wipe off excess oil.
Fence
Oil Type ...................................................Light Machine Oil
Oil Amount ..........................................................1–2 Drops
Lubrication Frequency .......................................As Needed
Place one or two drops of light machine oil on fence pivot
points (see
Figure 55
) as needed.
Figure 53.
Location (1 of 2) to lubricate
sliding ways on rear of jointer.
Lubricate
Sliding
Ways
Figure 55.
Fence lubrication locations
(black arrows).
Figure 54.
Locations to lubricate sliding
ways on front of jointer.
Lubricate
Sliding
Ways
