EinScan HX User Manual
59
Below shows the result of different ratios.
Original
Mesh optimization 10 Mesh optimization 50 Mesh optimization 100
Figure 3-44 Mesh Optimization
Click
Apply
to optimize data, preview the result of current setting.
Click
Confirm
to apply.
Click
Cancel
to quit and go back to the original data.
Multiple operations on Mesh Optimization, the result will not be added. It will always operate on
the original data.
3.7.3 Smooth
Smooth the possible noise on the surface of the scan data. It might remove some small details or
smooth some sharp edges at the same time. Set the ratio from 1 to 100, the default is 0.
Figure 3-45 Smooth Menu
The example of before and after smoothing is shown below. Run 2 times, data will be smoothed
twice.
Original
Smooth 10
Smooth 50
Smooth 100
Figure 3-46 Smooth
Click
Apply
to smooth data, preview the result of current setting.
Содержание EinScan HX
