Shindaiwa DGK15F, Руководство владельца и оператора

Страница: 38 / 52

35
(1) Engine Oil Replacement
First Time 50 hours
Thereafter Every 300 hours
Set a container to catch spilled engine oil.
Remove the oil filler cap.
After removing the oil drain plug, drain the engine
oil.
After the oil has been drained, close and tighten the
oil drain plug.
Add oil through the oil filler until it is at the
maximum level while checking the oil level using
the oil level gauge.
Attach the oil filler cap.
< Note >
 Refer to section “ 8-1. Checking Engine Oil ” for engine oil replacement amounts and types.
 After tightening the oil drain plug and shortly after starting the engine, be sure to always check that
there is no oil leakage.
 Always be sure to wipe up any spilled engine oil.

Replace the packing of the oil drain plug with a new part each time the oil is changed.

Packing part no. : 6C090-58961 (
Kubota part no.)
(2) Replacing the Oil Filter
First Time 50 hours
Thereafter Every 300 hours
Drain the engine oil. (Refer to section “(1) Engine Oil
Replacement ”.)
Remove the oil filter using a filter wrench.
Apply thin layer of oil on a new oil filter gasket.
Screw the oil filter by hand and securely tighten by hand (do
not use a filter wrench) after the gasket contacts the seal
surface.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check that there is no oil leakage
from the seal surface.
< Note >

Request the authorized distributor where the generator was purchased
to perform this procedure if you do not have a filter wrench.

Oil filter part no.: 1J090-32431 (Kubota part no.)
 Always be sure to wipe up any spilled engine oil.
2
3
4
5
Gasket
6
Oil Level Gauge
Oil Filler
Oil Drain Plug
Oil Filter
4
1
1
6
5
3
2