Shindaiwa DGK15F, Руководство владельца и оператора

Страница: 18 / 52

15
(2) Ammeter
Displays the output current (phase current) of the generator. Turn the ammeter selector
switch to “L1+U” to display the output current of the three-phase L1 phase and single-phase
U phase. Turn the switch to “L3+W” to display the output current of the three-phase L3 phase
and single-phase W phase. “L2” displays the output current of three-phase output terminal
L2.
< Note >

If measuring the output current for a single-phase three-wire type, turn the ammeter selector
switch to “L1+U” or “L3+W”. The voltage cannot be accurately measured if set to “L2”.
(3) Frequency Meter
Displays the frequency of the power source. Check that 60 Hz is displayed during operation.
Indicators
Check each illuminated warning indicator at the time of automatic stop, and inspect the failed
component.
(1) Pre-heating Indicator
The pre-heating indicator illuminates when the starter switch
is at START. The pre-heating indicator turns off when pre-
heating is completed. the preheating indicator turns off and
the generator starts.
< Note >
 Pre-heating completes in approximately 5 seconds.
(2) Pilot Lamp
This lamp illuminates when the engine is operating to indicate that power is being generated.
(3) Over Crank Indicator/No Speed Signal
This indicator lights up if the engine fails to start.
If that happens, set the STARTER SWITCH selector
to "STOP," and inspect the machine.
(Refer to section "
12. Troubleshooting ".)
If the LED light starts flashing, the rotation signal has
not been detected correctly.
In that case, contact the authorized distributor where
the generator was purchased
.
Pilot Lamp
Pre-Heating Indicator
OVER CRANK INDICATOR