Shindaiwa DGK15F, Руководство владельца и оператора

Страница: 13 / 52

10
5. Equipment
5-1. Three-phase and Single-phase simultaneous Output
This generator is capable of generating three-phase and single-phase three-wire output
simultaneously. (Three-phase output terminal and single-phase three-wire output terminal are
equipped individually.)
Neither switching operation of output nor switching operation of wiring is needed.
< Note >

Refer to section
“ 7-2. Connecting Load Cables ” for Load Connections.
 If using three-phase output simultaneously with a single-phase three-wire type output, use
in a range where the total current does not exceed the rated current.
5-2. Available Output Monitor
The available generated output for each output power source is displayed digitally. You can
use the display selector switch to change the display in the following order: three-phase,
single-phase three-wire U-W output, and single-phase three-wire U-N output, and single-phase
three-wire W-N output. Output of three-phase is always displayed when the engine is started.
< Note >
 Consider the digitally displayed available output as an
approximate estimate. Be sure to thoroughly consider the
displayed value and the used load capacity when using a load
such as a motor with large starting capacity.
 The displayed output capacity might not be correct values if
using a four-wire connection (single-phase using the N
terminal) for a three-phase output power source. Connect to a
single-phase/three-line type power source if using a single-
phase power source.
 If “- -” is displayed for the available output, it means that usage
has exceeded the rated capacity. Immediately stop the equipment being used and reduce the
load capacity of the equipment.
5-3. Spill Containment
WARNING : INJURY
 Do not open the check door when the starter switch is in the AUTO or START
position. It will cause injury by rotating parts such as cooling fans and fan belt.

Always turn the
starter switch to the STOP position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining
the engine or any equipment.
Three-Phase and Single-Phase Three-Wire Output Terminal
U W L1 L2 L3 N
GROUND
Display Selector Switch