４ INSTALLATION AND MAINTENANCE/INSPECTION
ＭＵＸ-１００ SERVICE MANUAL
４ - １４
４-2-8 User Setting
According to the request from the customer, change each user setting.
Ⅰ
How to enter user setting mode
Press and hold the user setting switch
for 3 seconds to change into user setting mode.
.
“usroPe” is displayed (for approximately 1 second), then the contents of user setting are displayed in the tube
voltage display unit. The contents of user setting can be changed by using the tube voltage setting keys “
△
”
and “
▽
”.
kV display
Item
PAS Power-assist
setting
Acc Acceleration
setting
StC Steer
control
setting
bAC
Backward power-assist setting
APO
Auto-power-off time setting
bON Buzzer
control
setting
LAP
Collimator lamp control setting
aPr
APR setting at the time of starting the apparatus
id
Apparatus ID setting
Table 4-6 Contents of User Setting
Ⅱ
How to return to normal use status
Press the user setting switch
in user setting mode.
At this time, if the contents of user setting are not registered by the registration key, the changing of contents are
canceled.
①
Press and hold the user setting switch
for 3 seconds.
③
②
The system enters the user setting mode such as PAS, Acc,
StC etc. (The photograph on the left shows the power assist
setting mode PAS.)
Change each set item using the tube voltage setting keys, and
register each set item using the registration key. When a set
item is registered, the system returns to the normal use status.
Press the user setting switch
to
return to the normal use status.
④
