57
(
15) Crankshaft pulley
Fit the key to the crankshaft, and install the crankshaft
pulley and tighten with the nut.
Crankshaft pulley tightening torque
274 – 333 N·m {28 – 34 kgf·m}
(16) Injection pump assembly
➀
Fit the shim, which has been removed at the time of
disassembly, connect the control rack of the injection
pump and link, and fix with the snap pin.
➁
Tighten the injection pump with bolts and nut.
Injection pump tightening torque
13 – 17 N·m {1.3 – 1.7 kgf·m}
166Y
167Y
(17) Injection timing adjustment
IMPORTANT : This Tier 3 type engine cannot inspect and adjust spill-timing.
If injection pump is replaced with new one, install same thickness shims with original pump.
(18) Drive gear ass’y (for hydraulic pump) · Hydraulic pump ass’y
Install the drive gear ass’y to the hydraulic pump and then install it to the gear case.
(19) Oil filter
Coat the mounting surface with a small quantity of oil and tighten by hand.
(20) Engine stop solenoid
Tighten the engine stop solenoid lightly with pliers.
Содержание ST330
