32
Other columns can be set in the same way
.
4.2.3 Working mode setup
The function of work mode setup allows the user to change work mode of any equipment
on the bus and can change work mode of all the 324 equipment on a circuit one-time.
The work mode setup interface is as follows:
Figure 4-26 Work mode setup
Select interface board number, circuit number and work modes to be changed in the
corresponding drop-down box; enter into address number of the equipment to be changed at
"Address"; and then click on OK button, work modes of relevant detector/module will be
changed and information of successful modification will be displayed.
Figure 4-27 Prompt of successful modification of work mode
If all equipment in a certain loop is required to be modified, enter 0 at "address".
The address value shall lie between 1 and 324, as each loop in the system can
accommodate 324 equipment at most. If out of range, the system will give the following prompt:
Figure 4-28 Prompt of address over-range
Click on OK and re-enter into correct address information.
4.3 Linkage
The linkage setup of this system adopts several unified man-computer interaction interface
and is suitable for the linkage relation setup in different zones or different linkage logics. The
goal is to reduce setup workloads of the user, facilitate the user to master setup methods and
decrease the mal-operations by the user. The submenu of bus setup is as follows:
