29
E
POWER SAVE MODE
When OFF is selected, startup time from standby mode is reduced. Note, however, that more power will be consumed in
standby mode. Android continues to run in standby mode.
When ON is selected, current consumption is reduced while the monitor is in standby mode. Android is also shut down. Note,
however, that the startup time from standby mode becomes longer.
If set to ON, certain RS-232C commands and LAN control cannot be used in standby mode. (See pages 38 and 49.)
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit
or RS-232C commands.
When the setting is ON, set the time until standby mode is entered in TIME.
POWER ON DELAY
When ON is set, you can delay the screen display after the monitor is turned on.
When ON is selected, set the delay time with INTERVAL (interval can be set up to 60 seconds in units of 1 second).
When this function is activated, the power LED flashes (at approx. 0.5 second interval) in green.
SELF ADJUST
On a D-SUB screen, specify whether to perform screen adjustment automatically or not.
When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of input
signals changes and other cases. “ADJUSTING” appears on the screen during the adjustment.
If SELF ADJUST is set to ON, set the time it takes to start the SELF ADJUST function in START TIMING.
For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Perform
manual adjustment of the screen.)
n
MULTI/PIP
MULTI
ENLARGE (See page 33.)
Sets whether or not to use the enlarge function.
ADVANCED (ENLARGE)
ENLARGE H / ENLARGE V
.......... Sets the number of screen splits (number of monitors) in the horizontal/vertical direction used for the enlargement.
ENLARGE-POS
.......... Specify the split screen to be displayed when the enlargement function is used.
H-POS / V-POS
..........Adjust the horizontal/vertical position of the enlarged screen.
BEZEL ADJUST
Sets whether or not to use the frame correction function.
ADVANCED (BEZEL ADJUST)
BEZEL ADJUST (TOP) / BEZEL ADJUST (BOTTOM) /BEZEL ADJUST (RIGHT) / BEZEL ADJUST (LEFT)
.......... Adjusts so that the top/bottom/left/right connecting joints of grouped units will be displayed smoothly when a group
of monitors are aligned in multiples to display a single image.
BEZEL (TOP) / BEZEL (BOTTOM) / BEZEL (RIGHT) / BEZEL (LEFT)
.......... Sets the frame width of the display.
Menu Items
