MX-M753N MX-LCX3N 3 – 10
[When shifted to the rear side]
When shifting the print line from the paper center in the arrow direc-
tion as shown below:
2) Loosen the blue off-center adjustment screws (each 2 pcs.), and
move the side plate by the dimension shifted in the direction B
(F side), and tighten the blue screws.
NOTE: Note:Move the side plates by the same dimension on the
front side and the rear side.
3) Push the large capacity tray slowly into the original position.
Then make a copy again to check to insure that there is no more
shifet. Repeat this procedure as required.
(3) Mechanical adjustment-2
Since the regulation plates are adjusted when shipping, there is
basically no need to readjust. If, however, diagonal feed is poorly
operated, adjust the regulation plate width and the diagonal feed in
the following procedures:
a. Regulation plate width adjustment
1)
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the large
capacity tray.
2)
Set a sheet of paper on the paper feed base tray. Check that
the front regulation plate is at the marked center, and push it in
contact with the front regulation plate. Loosen the blue screw
of the rear regulation plate.
3)
Use the mark of the rear regulation plate, and fix the blue
screw at the position so that the clearance between paper and
the rear regulation plate is evenly 1mm.
NOTE: The positions of the regulation plates are even to the right
and left marks.
1mm
