MX-M753N MX-LCX3N 3 – 3
C. Attach the upper mounting plates and the
lower front/rear connecting plates.
1)
Attach the two upper mounting plates with the rubber portion
(
★
) down to the right side of the main unit using screws A (two
for each).
2)
Remove the fixing screw of the front/rear cover on the lower
right side of the main unit. Attach the lower front side
(engraved mark F) of the connecting plate to the lower front
side of the main unit with two fixing screws B.
Attach the lower rear side (engraved mark R) of the connecting
plate to the lower rear side of the main unit with two fixing
screws B.
3)
Remove the fixing screws (2 pcs.) of the machine entry port,
and remove the entry port cover.
4)
Reverse the entry port cover and re-attach it to the machine.
Secure it with the two previously removed screws in procedure
3.
D. Installation to the machine and height
adjustment
1)
Use the edge of the connection plates F/R mounted to the
lower side of the machine and the mark on the mounting plate
in the lower left side of the LCC to check the installation height.
F side
R side
a. When the height is properly adjusted
When the top edges of the F/R mounting plates on the
machine line up with the center mark of the mounting plates on
the large capacity tray, as shown in the illustration below, then
the height of the tray is within specification. At this point the
front and rear fixing plates can be installed and secured with
the supplied screws (shown in the illustration on the next
page).
F side
R side
Engraved
mark F
Engraved
mark R
F
R
