MX-7000N MX-CFX1 5 – 8
H. Check the clearance of the main unit and the
inserter
1)
Put the inserter that has installed the finisher (Punch unit)
close to the main unit.
2)
Check from back and forth to insure that the upper and lower
clearances between the main unit and the finisher are even.
* When the upper and lower clearance is even, progress to
the procedure of "I. Touch of the auxiliary caster with the
floor".
When the upper and lower clearance is not even, progress
to the following procedures.
3)
Remove each cabinet on the front and the rear side of the fin-
isher, and loosen the fixing screws of the front and rear caster
on the left side.
* The adjustment procedure is different according to the
installed finisher. For details, refer to the adjustment proce-
dure of each finisher.
4)
Use a spanner to turn the height adjustment bolt on the front
and the rear side so that upper and lower clearance is even.
