Sharp AQUOS R, Руководство пользователя

Страница: 170 / 182

168
Handset & Hardware Care
Handset & Hardware Care
・Use handset within 5
o
C - 35
o
C and 35% - 90% humidity.
For use in bathrooms, see " Cautions for Use in a Bathroom ."
・Avoid extreme temperature or direct sunlight.
・Handset/Internal Battery may become warm during operation
or while charging. This is normal.
・Warranty does not cover malfunctions resulting from
misuse.
・Soiling on terminals can cause a poor connection and
inadequate charging; wipe terminals with a dry cloth or
cotton swab.
・When cleaning ROBOQUL power connection terminal, be
careful not to deform it or touch it.
・Clean handset with a soft dry cloth. Alcohol/solvent use
may fade color/print.
・Avoid scratching Display.
・Avoid heavy objects or excessive pressure. May cause
malfunction or injury.
・Do not sit on handset in back pants pocket.
・Do not place heavy objects on handset inside handbags,
packs, etc.
・Handset back cover is not removable. Do not try to remove
it; may cause damage or malfunction, or affect water and
dust resistance.
・Connect only specified products to Jacks. Other devices may
malfunction or cause damage.
・Do not power off while using SD Card; may result in data
loss or malfunction.
・When walking outside, moderate handset volume to avoid
accidents.
・If thunder is audible while outdoors, discontinue use; there
is a risk of lightning strike or electric shock.
・When holding handset, do not block Earpiece, Mic, Speaker,
or Recorder Mic.
・Proximity Sensor prevents Touchscreen misoperation during
calls. Do not cover or place a sticker/label over Proximity
Sensor; Display may remain off during calls, disabling
handset operation.
・If your hair is between Earpiece and your ear during calls,
Proximity Sensor may not function properly.
Display may remain on; touching Display accidentally may
end the call.
・Do not cover Light Sensor or place a sticker/label over it;
may hinder ambient light detection, resulting in malfunction
of Light Sensor.
・Handset Earpiece is located at the center of Display upper
end. If other party's voice is hard to hear during calls, hold
handset so that Earpiece is next to your earhole for better
audibility.
USIM/SD Card Insertion/Removal
With Display upward, insert USIM Removal Tool in removal hole
in Card Tray
・Press firmly and straight until Card Tray ejects.
・With Display upward, pull out Card Tray. Pulling out Card
Tray with Display downward or handset held upright can
allow USIM Card and SD Card to fall from Card Tray and
become misplaced.
・When removing Card Tray, do not pull forcefully or at
an angle; damage may result. Gently pull Card Tray out
horizontally.
Insert/remove USIM/SD Card
・Note placement and orientation of USIM Card/SD Card and
set in Card Tray.
・USIM Card/SD Card
・Note orientation of USIM Card/SD Card before setting
in Card Tray. Set with notches aligned and IC (gold) chip/
terminals facing down.
・Make sure USIM Card and SD Card are in Card Tray.
Inserting Card Tray with USIM Card or SD Card on its edge
may cause damage.
Insert Card Tray in USIM/SD Card Slot
・Do not insert Card Tray upside down.
・Insert gently all the way horizontally in direction shown.
・Push Card Tray firmly where circled (○) so that there is no
gap between handset and Card Tray.