SharkRF openSPOT3, Руководство пользователя

Страница: 119 / 131

DMR radio : the color code (CC) match in your radio and the openSPOT3 (example: set it to the default 1).
Make sure the talkgroup you want to hear is set as the TX contact of your DMR radio's currently active
channel, or the talkgroup is in an RX group list which has been assigned to the currently active channel. You
should also add TG9 to your the RX group list and assign it to the currently active channel to hear the
openSPOT3's voice announcements.
C4FM radio : the DGID is set to the same value both in your radio and the openSPOT3 (example: set it to the
default 0).
NXDN® radio : the radio access number (RAN) match in your radio and the openSPOT3 (example: set it to
the default 0). Make sure the talkgroup you want to hear is in your NXDN® radio's contact list, or it is set as
the TX contact of the currently active channel.
No one is hearing me on the network
Please read the Setting up your transceiver section.
Check where your radio is sending your call by looking at the Call log on the openSPOT3's web interface. Make
sure your radio is sending the call to the desired talkgroup or reflector.
The openSPOT3's status LED should blink green when you press the PTT on your radio:
If not, then make sure the openSPOT3 and your radio are on the same RX and TX frequencies.
Make sure the openSPOT3's modem is set to the same mode as your radio, and the following settings are set:
DMR radio : the color code (CC) match in your radio and the openSPOT3 (example: set it to the default 1).
C4FM radio : the DGID is set to the same value both in your radio and the openSPOT3 (example: set it to the
default 0).
NXDN® radio : the radio access number (RAN) match in your radio and the openSPOT3 (example: set it to
the default 0).
If you are using a D-STAR® radio , then make sure your D-STAR® network registration is valid on this page. If
you use a Kenwood TH-D74A transceiver, then make sure the Direct Reply feature is turned off, as it basically
causes automatic callsign routing, which could cause one's transmission to not be heard on the used reflector.
The openSPOT3 can't connect to the selected server
If the status LED is pulsating like this, then the openSPOT3 is trying to connect to the selected server, but it can't
for some reason. If it's not pulsating like on the animation, check the
LED states section for more information
about the current LED state.
Troubleshooting
119