SharkRF openSPOT3, Руководство пользователя, Страница: 118 / 131

You can also find more information on the Connecting the openSPOT3 to a Wi-Fi network page on the steps
required to set up the openSPOT3's Wi-Fi connection.
The web interface only loads partially
Make sure you use a supported browser (Chrome, Firefox or Safari), and that the browser is updated to the latest
version.
If you're trying to do the initialization setup (the openSPOT3's status LED is white), then place the openSPOT3
close to your browser device (phone/tablet/computer) during the setup.
Otherwise, try placing the openSPOT3 closer to the Wi-Fi access point (your Wi-Fi router).
The openSPOT3 can't connect to my phone's Wi-Fi network
Note for iPhones: the phone's hotspot settings page needs to be open all the time during the openSPOT3 Wi-Fi
setup because the iPhone will only broadcast it's own Wi-Fi network if the internet share hotspot settings page is
open.
First you should connect your openSPOT3 to your home Wi-Fi network and then when it's connected (status LED
is green or green/yellow) open the web interface using
sharkrf.link . After that you can set up additional Wi-Fi
networks if you turn on Advanced mode (checkbox at the bottom right corner of the web interface) and go to the
Network page, Wireless settings section. Enter your phone's hotspot SSID and key as the 2nd Wi-Fi network.
After that if the openSPOT3 can't connect to your home Wi-Fi network it will also try connecting to your phone's
Wi-Fi network.
I'm not hearing anything on my radio
Please read the Setting up your transceiver section.
Check if your radio's LED is on when the openSPOT3 is transmitting. The openSPOT3 is transmitting if it's status
LED is blinking red:
If it's blinking alternating red/orange, then BCLO is on:
If this is the case then make sure it's turned off by setting it to 0 at the Other modem settings section.
If your radio's LED does not turn on when the openSPOT3 is transmitting, then make sure they are on the same
RX and TX frequencies.
Make sure the openSPOT3's modem is set to the same mode as your radio, and the following settings are set:
Troubleshooting
118