The
RSSI graph
shows receive signal strength from the modem. The
BER graph
shows received Bit Error Ratio
during a call. BER is calculated also for packets received from the network, not just from the modem. The
dejitter queue graph
(only shown if Advanced mode is enabled) shows the number of packets waiting in the
dejitter queue.
About the dejitter queue
All packets received from the network will first go to this queue to eliminate
network jitter
.
If the dejitter queue
length is too short
, the
graph's line can touch zero
during a call and the
audio can stop for
a moment
as the modem runs out of frames to transmit.
If the queue's length is
too long
, the delay can be uncomfortably high.
You can use this graph to set a proper dejitter queue length. There should be at least a few packets in the
dejitter queue when receiving a call from the network. You can set the dejitter queue length on the
(the setting only shows up if Advanced mode is enabled). As a
connection to the selected connector's server, set dejitter queue length to 500ms, and if you have a 3G/4G
internet connection or voice stutters a lot, try setting the length to at least 1000ms.
Status page
45
Содержание openSPOT3
