SGMW Baojun 530, Сервисное и эксплуатационное руководство пользователя

Страница: 159 / 215

Driving and Controls 151
8
Dr
iv
ing
an
d Co
ntrol
s
7-seat Model
1. Open the liftgate and remove luggage compartment
floor mat. As shown in the figure, there is one bolt on
the storage box bottom board that serves as the shaft
of spare tire lifter.
2. Use a wheel nut wrench to rotate the shaft
counterclockwise until the spare wheel lowers to the
ground.
3. Tilt the holding plate at the end of wire rope and pull it
out of the center hole of the wheel.
Spare tire reassembling procedures:
1.
Have the spare tire valve to face upwards and then tilt
the holding plate at the end of wire rope to make it
pass the center hole of the wheel.
2. Use a wheel nut wrench to rotate the shaft clockwise
until the spare tire is lifted off the ground.
3. Check whether the holding plate holds the spare tire
securely.
4. Continue to raise the spare tire until it is tight against
the lower part of the vehicle. The wire rope is
tensioned moderately but not too tightly to guarantee
that it can hold the spare tire firmly.
5. Try to turn the spare tire to check that it is secured. If
the tire is movable, it is necessary to further tighten
the lifter shaft.
6. Put tools and the jack back into the tool kit.
Jack Lifting Point
As shown in the figure above, the jack lifting points are
around the side wall skirt, and there are triangle marks in
corresponding parts for the convenience of searching.
These lifting points are also lifting points of the lifter, and the
lifter tray should be aligned with the triangle mark. The lifting
points have been specifically strengthened. Please be sure
to align them.