SGMW Baojun 530, Сервисное и эксплуатационное руководство пользователя

Страница: 134 / 215

126 Vehicle Service & Maintenance
General Information
Accessories and Vehicle Retrofitting
We recommend using original spare and accessory parts
and parts and components that are approved by the
company to be particularly suitable for the vehicle. We may
not able to guarantee the compatibility of other products with
this vehicle, even if these products meet the specified
requirements or are otherwise approved.
For parts of environmental protection, including the engine,
transmission, coating, fuel evaporation control device,
crankcase emission control device, OBD, ECU, catalytic
converter, muffler, EGR (if any), supercharger (if any) and
intercooler (if any), it is preferable to use original spare and
accessory parts. Otherwise, vehicle emissions may not
meet the standard.
The Company is not responsible for any problem caused by
the use of non-original parts and components (including but
not limited to the non-compliance of environmental
emissions due to the use of non-original parts and
components or other violations of laws and regulations).
Without the approval of
SGMW , do not retrofit the electrical
system.
Tips for Glass Filming
During the process of glass filming, the cleaning solution
may easily enter electronic components around the
instrument panel, causing electrical faults. Please complete
waterproofing work before filming.
Caution
Do not retrofit the vehicle. Otherwise, the
performance, durability and safety of the vehicle may
be affected; problems caused by retrofitting are not
within the scope of warranty.
Vehicle Storage
Long-term Storage
Several months of storage of the vehicle:

Clean the vehicle for waxing.

Check the wax coating of engine compartment and
the underbody.

Clean and protect the rubber seal.

Replace the engine oil.

Drain the washer fluid reservoir.

Check coolant antifreezing agent and corrosion
protection.

Adjust the tire pressure according to the specified
value under full load.

Park the vehicle in a dry and well-ventilated area. Shift
to Gear 1 or reverse gear to prevent the vehicle from
sliding.

Close all doors and lock the vehicle.

Disconnect the clip from the vehicle battery negative
terminal. Pay attention to that all systems are out of
service at this time, e.g. theft deterrent system.
Vehicle being Put into Operation again:

Connect the clip to the vehicle battery negative
terminal. Enable the electronic device of power
window.

Check the tire pressure.

Fill the washer fluid reservoir.

Check the engine oil level.

Check the coolant level.