SGMW Baojun 530, Сервисное и эксплуатационное руководство пользователя

Страница: 143 / 215

Driving and Controls 135
8
Dr
iv
ing
an
d Co
ntrol
s
Windshield Wiper
Foreign objects on the windshield and blade will reduce the
effectiveness of the wiper. If the blade does not work
properly, wipe the windshield and the blade with special or
neutral washer solvent. Flush with water thoroughly. If
necessary, repeat the above operation. Do not wipe the
windshield with corrosive substances or materials that
cannot be removed from the glass (e.g. silicone).
The strips have a layer of graphite on the surface for
lubrication and protection. It should be protected from
excessive wiping and undue polishing.
Do not start the wiper when the windshield surface is dry.
Park the vehicle in a cool place as far as possible to prevent
exposure to high-temperature, which will accelerate the
aging and deformation of strips.
Remove foreign matters such as bird droppings, dust and
leaves from the windshield surface before starting the wiper;
otherwise, the service life of strips will be reduced.
Notes on Front Wiper Blade Replacement:
The front wiper is of semi-concealed design. Before
replacing the blade, operate the wiper to the maintenance
position and then fold the wiper arm. Otherwise, the right
wiper arm will contact the engine hood and damage the
paint when being folded.
Method: Turn the ignition switch to ON position and then to
LOCK position. Raise the wiper lever towards the steering
wheel and release it (single-point contact) within 30s, and
the wiper arm will swing to the maintenance position. After
replacing the blade, lower the wiper arm and turn the ignition
switch to ON position, and then the wiper will return to the
original position.
Wiper Blade Removal and Installation
Fold the wiper arm on the windshield for operation.
As shown in the figure, firstly press the release switch of the
wiper blade in the direction of arrow 1. Then hold the joint
part between the wiper blade and the wiper arm with the
other hand. Pull the wiper blade down slightly in the
direction of arrow 2 to separate the wiper blade from the
wiper arm.
During installation, insert and clamp the new wiper blade
into the U-slot of the wiper arm.
During the rear wiper blade removal, pull out the wiper blade
from the installation point on wiper arm. For installation,
align the blade with the installation point and press it into the
point.
Air Filter
Check and replace the air filter element regularly according
to the maintenance instructions in the Manual.
Air Filter Cleaning
If the air filter element is too dirty, clean it according to the
following procedures:
1.
Shake the air filter element to remove floating dust.
2. Clean the interior of air filter housing.
3. Cover the filter housing with a wet cloth when cleaning
the filter element.
4. Clean the filter element with compressed air in the
opposite direction of the engine intake.
Note
Clean air is necessary for the normal operation of
engine.
It is prohibited to drive the vehicle without the air filter
element being installed. Otherwise, the engine will be
damaged.