SEW-Eurodrive ECDriveS ECIO-8-24-00, Руководство пользователя

Страница: 32 / 43

6
Startup
32
Manual
– ECDriveS® ECIO
Note
②
Fehler! Verweisquelle konnte nicht ge-
funden werden.
PushPull
4:0496 M: 4:13803
E: I.Data[3] Push/Pull Inputs Configuration
0 = Input circuit Not Push-Pull type
1 = Input circuit is Push-Pull type
bit 0 : Left Male Pin2
bit 1 : Left Female Pin2
bit 2 : Right Male Pin2
bit 3 : Right Female Pin2
bit 4 : Left Male Pin4
bit 5 : Left Female Pin4
bit 6 : Right Male Pin4
bit 7 : Right Female Pin4
bit 8 to bit 15 - reserved
See
Note
③
State On Dis-
connect
4:0255
M: 4:13804
E: I.Data[4] Output State on Disconnect Configuration
0 = Output Pin de-energizes upon communication
loss with remote controller
1 = Output Pin remains in last state upon communi-
cation loss with remote controller
bit 0 : Left Male Pin2
bit 1 : Left Female Pin2
bit 2 : Right Male Pin2
bit 3 : Right Female Pin2
bit 4 : Left Male Pin4
bit 5 : Left Female Pin4
bit 6 : Right Male Pin4
bit 7 : Right Female Pin4
bit 8 to bit 15 - reserved
See
Note
④
Note ①
This register is only used for Pins configured as Inputs in the Input/Output register. If a
given Pin’s corresponding bit is 0 in this register, the logical state of the Pin’s data seen in
the Inputs register of the Inputs Assembly will match the logical state of t he electrical
signal on the Pin. If a given Pin’s corresponding bit is 1 in this register, the logical state of
the Pin’s data seen in the Inputs register of the Inputs Assembly will be inverted from the
logical state of the electrical signal on the Pin.
This is provided as a convenience for the remote controller programmer. For example,
the remote controller could have re-useable code or routines that expect a photo sensor
to have its electrical signal ON when it is “blocked”. Let’s say on a given module, you
need to connect a photo sensor whose electrical signal is OFF when “blocked”. Instead